forum.wfiltericf.com

Posted: **Wed Dec 01, 2010 1:57 am**

My cisco switch does not allow outgoing traffic on the mirroring port.

So I installed a secondary Nic.

Trying to setup blocking but to no avail.

On the Monitoring Device settings the new Nic does not show up.

Posted: **Wed Dec 01, 2010 2:11 am**

Restarting of monitoring service is required for WFilter to recogonize the new NIC.

Please click "Start"->"IMFirewall WFilter"->"Tools"->"Restart Monitoring Service" to restart the monitoring.

If the new NIC still doesn't show up, please reboot you computer.

Posted: **Sat Dec 04, 2010 5:05 am**

It works after restarting monitoring service. Thanks.

forum.wfiltericf.com

New blocking NIC does not show up in WFilter "Monitoring Settings".

New blocking NIC does not show up in WFilter "Monitoring Settings".

New blocking NIC does not show up in WFilter "Monitoring Settings".

New blocking NIC does not show up in WFilter "Monitoring Settings".